The quote is free and you see the price before work begins. No surprise charges at the end.
We photograph the damage, log moisture readings and send the paperwork your adjuster asks for, so you have less to chase.
Call now and a real person picks up. We ask a few questions and send a crew, so the water stops spreading sooner.
You do not have to work out how bad it is on your own. Call, tell us what you see, and an Elk Grove technician will explain the next step and what it should cost.
There are two ways an attic ends up wet. Rain gets in from above through worn shingles, failed flashing, or the seals around vents and chimneys. The house itself sends moisture upward too, and in a poorly ventilated attic it condenses on cold sheathing. Whichever it is, few people ever go up and look. Our team in Elk Grove inspects the attic, finds the source, and dries it out.
On the typical attic job, soaked insulation is the main issue. Heating and cooling bills go up because cellulose and fiberglass alike give up R-value when wet. Even worse, it keeps water pressed against the framing and the ceiling drywall for weeks. Our process is to pull the saturated insulation, dry the wood using dehumidifiers and air movers, and treat mold found on rafters or sheathing.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Call (612) 464-8281| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Cellulose insulation | Only the surface is damp and it is still loose | Packed or soaked to the bottom, the usual result |
| Recessed lights and wiring | They check out dry and corrosion free when an electrician inspects them | Water got inside the housing or connections show rust |
| Insulated ductwork | Outer jacket is intact and the insulation inside stayed dry | The wrap holds water, has grown mold, or is pulling the duct down |
| Rafters and joists | The wood is solid, with only surface stains or a little mold | Rot that a screwdriver sinks into, or visible cracking |
| Roof sheathing | Stained but solid, and it dries back to normal moisture readings | Soft, sagging between rafters, or its layers are separating |
The insulation catches and absorbs whatever rain gets by the roofing. Because the rooms below show nothing, the leak is missed and no roof repair happens.
Damp wood and paper facing in a warm, still attic are ideal for mold. The sheathing, along with the top face of the drywall ceiling, is where growth can begin.
After repeated wetting, the insulation is saturated and water reaches the ceiling. Brown rings appear in the room below, and the drywall may start to sag.
Sheathing delaminates and loses its hold on the roofing nails. Large areas of roof decking are covered in mold, while rafters that never dry begin to decay.
Many attics hold an air handler, a drain pan and condensate lines. When the pan overflows or the drain clogs, insulation gets wet for weeks without any rain as a warning.
Poorly ventilated attics often grow mold across the underside of the sheathing. It can cover a wide area before anyone goes up to look.
A bathroom fan that vents into the attic instead of outdoors adds warm, moist air every day. On cold sheathing that air condenses, and the result is easy to mistake for a leaking roof.
Insulation full of water weighs a lot. Wet from above, drywall loses strength at its fasteners and may fall without warning, with the wet insulation coming down too.
Our inspection covers the flashing points, roof deck, exhaust ducts and vents, and tells us if the water is condensation, a leak, or both. Thermal imaging and moisture meters show how far it reached.
Insulation that is soaked or has mold gets bagged and carried out, giving the wood and the drywall below a chance to dry. Rooms under the attic are protected, and the route in and out stays contained.
With dehumidifiers and air movers, the sheathing, joists and rafters return to normal moisture levels. Visible mold is cleaned from the wood and an antimicrobial is applied.
You are shown the ventilation or roof problem to be corrected, and our findings can go to your roofer. When the attic has stayed dry, the R-value is restored with new insulation.
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (612) 464-8281Don't wait for small problems to become expensive emergencies. Call Elk Grove Restoration for fast, reliable service.
Call (612) 464-8281 Now